The Star V Method: Tape, Groove & Fold

See the process

From a flat sheet to a folded profile.

Tape is automatically applied to the bottom of the sheet before V-grooves or miter cuts are machined into the top. The tape holds the pieces together as the part is folded and glued.

Star V SLG 2000 dual-head V-grooving machine with roller feed bed
Star V SLG 2000 — two tape applicators, two cutter heads and automatic servo adjustment.

Follow the tape, groove and fold sequence

These real machine and sample photographs show the key stages. Top and bottom describe the sheet as it is positioned in the machine, not the final orientation of the finished part.

Actual Star V automatic tape applicators mounted beneath the machine bed

1. Tape before machining

The automatic applicator places tape on the bottom of the sheet along the intended fold line before machining, reducing separate taping and handling steps.

Actual Star V cutter heads and V-grooving tooling with guards open

2. Machine the profile

The cutter machines V-grooves or miter cuts into the top of the sheet while the tape underneath remains intact. Choose V-groove or special cove tooling to suit the part.

Actual panel cross-section with two V-grooves prepared for folding

3. See the prepared grooves

This sample shows two V-grooves before folding. Groove locations and geometry follow the finished profile; the tape underneath holds the pieces together for assembly.

Actual folded solid surface profile and right-angle corner samples

4. Glue, fold and finish

The tape acts as a hinge during folding and gluing. After the adhesive cures, remove the tape and complete any required finishing. Assembly follows machining as a separate step.

The tooling photograph shows the actual cutter assembly with its guards open for reference. The final photograph shows completed profile samples; it does not depict adhesive application.

See the profiles this method can help prepare

Start with the finished cross-section, then match the material, groove layout and tooling to the required result.

Actual wood-finish panel sample folded into a right-angle edge

Drop edges & front-edge buildups

Machine the V-groove into the top of the sheet, leaving the tape on the bottom intact to hold the pieces together as the edge is folded and glued. The same miter-folding principle supports column wraps, buildups and floating shelves.

Solid surface cove-profile sample from the Star V USA photo collection

One-pass cove backsplashes

For solid surface work, special cove tooling can machine the cove profile in one pass. Pre-taping and a combined cutting operation reduce separate preparation and machining steps. The photo shows a finished profile sample.

Actual solid surface sample showing multiple folded faces

Bevel & double-edge profiles

Discuss angled edges and multiple-fold profiles. Cutter geometry, head arrangement and the required number of passes depend on the part and machine. This sample illustrates multiple faces; confirm your specific angle and edge detail.

Two-piece cove construction

When sheet width will not accommodate both the front drop and backsplash, a separate upright and horizontal panel can provide another route. Confirm the cove radius, mating cuts and assembly method with Star V USA.

Designed for straight runs

This method works along straight fold lines. Round, curved or arched countertop edges require a different approach. Share your material, thickness and drawing so we can confirm a suitable setup.

Review mitered stair-end applications · Compare production savings and estimate payback

See the method on your own part

Bring a drawing or sample, the material and thickness, and your production goals. We can review the groove layout, tooling and machine configuration together.

Compare Star V machines